How To Lower Your Bed Frame

Home - Diy

How to Lower the Mattress on a Bed Frame

Bed frames are constructed in diverse means. On some, the mattress and box leap rest on wooden rails screwed into the inside bed track. Others have a metallic framing that bolts to the frame rails.

Lowering the mattress height can help small-scale children go into their beds.

In some cases, in that location is no manner to move the railing from the bed runway, so drastic measures are required to lower the height of the mattress in the bed frame.

• Tape measure
• Drill
• Drill bit set
• Screwdriver
• Flat wood saw
• Sandpaper

1. Remove the bedding, mattress and box bound from the bed frame and place them off to the side.

2. Inspect the inside of the frame track. If the frame rails take wooden strips attached to the side to hold the box spring in identify, inspect the strips for screws. If the wooden strips take screws, remove them with a screwdriver and place the strips off to the side. If the wooden rail practise not have screws, they are likely glued in place using dowel pins. Y'all cannot remove the wooden rails. If this is your case, skip to Stride 6. If the frame runway have a metallic frame attached for holding the box spring, remove the screws or bolts that hold the frame rail in place and set the bolts off to the side.

3. Measure down from each mounting hole with a tape measure and place a mark on the inside of the frame rails. For case, if you want to lower the mattress five inches, place the mark 5 inches inches below the hole. Yous are limited simply by the width of the frame rail in how far you can lower the mattress in the bed frame.

4. Drill pilot holes approximately half the diameter of the screws or bolts used to concord the box bound track in identify.

5. Place the wooden rails or the metal frame against the frame rails and line upwardly the rails with the new holes. Secure the runway or frame to the bed frame with the original screws or bolts.

6. Measure upwardly the legs of the bed with a tape mensurate and place a line that marks the distance y'all want to lower the mattress. For example, if you want to lower the top of the mattress v inches, place a mark on each leg that is five inches from the floor. Cutting the legs off at the mark with a flat wood saw and then remove whatsoever crude edges with sandpaper. This applies only to beds with wooden frames from which you cannot remove the box spring rails.

7. Place the box jump, mattress and bedding dorsum onto the bed frame.

The Baste Cap

• Bed frames are constructed in various ways.
  
• You cannot remove the wooden rails.
  
• If the frame rail accept a metallic frame attached for belongings the box leap, remove the screws or bolts that hold the frame runway in place and set up the bolts off to the side.
  
• Secure the runway or frame to the bed frame with the original screws or bolts.
  
• For example, if you want to lower the height of the mattress five inches, place a mark on each leg that is five inches from the floor.

Source: https://homesteady.com/12493534/how-to-lower-the-mattress-on-a-bed-frame

Share this post